Scheppach BTS900 Translation From The Original Instruction Manual

24 GB
15. Troubleshooting
Problem Possible Cause Help
Motor doesn’t
start
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
a-d) Replace all damaged parts before
you use your machine again.
e) Contact your local service centre.
Every attempt to carry out a repair,
can be dangerous if it is not done by
skilled personnel.
Machine gets
slower during
work.
Too much pressure put on the
workpiece.
Reduce the pressure on the workpiece.
Sanding belt
comes off the
drive pulleys.
Belt does not run straight. Reset the track.
The wood gets
burnt during
sanding.
a) Sanding disc or belt covered with
grease.
b) Excessive pressure on
workpiece.
a) Replace disc or belt.
b) Reduce pressure on workpiece.

Scheppach BTS900 Specifications

General

Motor Power	900 W
Belt Size	915 x 100 mm
Disc Diameter	150 mm
Table Size	190 x 125 mm
Weight	18 kg
Power Input	900 W
Disc Speed	2850 rpm
Dust Extraction	Yes
Sanding Disc Diameter	150 mm
Belt Speed	7.5 m/sec