www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
36
|
GB
Trimming (Fig. I)
Attention: Leave stubs in branches or below cut
above shoulder height. Leave such work to an expert.
•
limb.
•
through the branch. The third section (item 3) is
branch at 2.5 to 5 cm from the trunk.
Sawing on a slope (Fig. K)
stand higher than the tree trunk (Fig. K). In order to
maintain complete control at the moment of “sawing
through”, reduce pressure towards the end of the
of the chainsaw.
Warning!: The saw chain must not come in contact
with the ground..
After completing the cut, wait for the saw chain to
come to a standstill before removing the chainsaw.
from one tree to the next.
10. Maintenance
• Keep the cooling vents on the motor housing clean
and unobstructed at all times.
•
Customer Service.
•
• Should the chainsaw fail despite our careful
manufacturing and inspection procedures, have it
shop.
Filling in chain oil
To prevent dirt getting inside the tank, clean the oil
tank cap (21) before opening. Check the contents of
Sharpening the saw chain
also obtain chain sharpening equipment to enable
Please follow the corresponding operating
instructions.
Follow the maintenance regulations and the
instructions for changing tools
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use as
consumables. Wear parts*:
• Saw chain
• Guide bar
• Chain oil
• Carbon brushes
• Claw stop
11. Storage
•
chain guard.
•
of children.
• When the device is not being used, store it so it
Warning!
Do not store the device without protection outside or
in a damp environment.
12. Electrical Connection
to work. The connection complies with the relevant
VDE and DIN regulations.
extension line must meet these regulations.
• The product meets the requirements of EN
61000-3-11 and is subject to special connection
conditions. This means that use of the product
allowed.
•
•
points that
impedance “Z”, or
the mains of at least 100 A per phase.
•
wish to operate the product meets one of the two
requirements, a) or b), named above.
To Next Page
Loading...
Need help?
General
