www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
31
• Use a surge protector with a release current of
30 mA or less.
•
•
service instructions in this manual.
• Practise using the saw (sawing logs on a sawhorse)
and get an experienced user or a specialist to
working, the techniques of sawing and the personal
protection equipment.
6. Technical data
Cutting data chainsaw
Cutting lenght cm 44
Bar lenght cm 45,5
Cl 0.2
T wear resistant oil
Saw chain division
Drive link thickness mm 1.27
S 3/8,050x62DL
Number of teeths drive
sprocket
7 x 9,525
Tooth pitch of drive sprocket
Chain brake
G AP18-62-507P
Engine
Motor V / Hz 230-240 V / 50 Hz
Power W 2400
Cutting speed max. m/s 15
Weight kg 5
Weight without bar and chain
kg
4.3
Subject to technical changes!
Information concerning noise emission measured
according to relevant standards:
Sound pressure L
pA
= 95.6 dB(A)
Sound power L
WA
= 104.5 dB(A)
Guaranteed Sound power LWA = 107 dB(A)
PA
= 3 dB(A)
Wear ear-mus.
The impact of noise can cause damage to hearing.
Vibration A
hv
(front handle) = 6.02 m/s
2
Vibration A
hv
(rear handle) = 6.55 m/s
2
PA
= 1,5 m/s
2
•
measured according to a standardised testing
procedure and can be used for comparison of one
electric tool with another;
•
used for an initial assessment of the load.
Warning:
•
which the electric tool is used;
•
possible. Some examples of means for reducing
the vibration stress are wearing gloves while using
the tool and limiting work time. In the process all
account (such as times in which the electric tool is
not running under a load).
7. Attachment and operation
Warning!
the prescribed insulation and connections designed
for outdoor use (approved rubber-sheathed cables)
requiring the use of both hand. The chainsaw works
at the same time. If the chainsaw does not run, the
(3). Be sure to read the sections “Chain brake” and
“Releasing the chain brake “ on this point.
Assembly
Fitting the guide bar and chain (Fig. 1, 2, 3)
Warning!
the saw chain.
in the top (vertical) position (Fig. 5).
guide bolt (17) must be in the centre of the guide.
chain wheel (Fig. 3, 5).
Warning!
tensioning and checking the chain.
Before assembling the guide bar with the saw chain,
check the cutting direction of the teeth!
To Next Page
Loading...
Need help?
General
