www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
37
Old devices must not be disposed of with
household waste!
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
electrical and electronic equipment. Improper
consequences for the environment and human
are often contained in electrical and electronic
resources. You can obtain information on collection
Important information
In the event of an overloading the motor will switch
motor can be switched back on again.
Defective Electric Connection Lines
Often, insulation damages occur on electrical
connection lines.
Causes are:
• Drag marks if connection lines are led through
window or door clearances.
• Kinks due to improper attachment or routing of the
connection line.
•
•
connection line out of the wall socket.
•
Such defective electric connection lines must not
be used and are hazardous due to the insulation
damages.
damages. Please make sure that the connection
the check.
connection lines labelled with H05VV-F. The labelling
is required.
AC motor
• The mains voltage must be 230-240 V~.
• Extension leads up to 25 m in length must have a
cross-section of 1.5 mm
2
. Extension leads whose
length is over 25 m must have a cross-section of
at least 2.5 mm
2
.
Please provide the following information in the event
•
•
•
13. Disposal and recycling
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
equipment and its accessories are made of various
Defective components must be disposed of as
To Next Page
Loading...
