31GB
15. Troubleshooting
Problem Possible cause
Help
Motor does not work Motor, cable or plug defective, fuses burnt
Housing cover open (limit switch)
Arrange for inspection of the machine by a
specialist. Never repair the motor yourself.
Danger!
Check fuses and replace as necessary
Close housing cover exactly
The motor starts up
slowly and does not
reach operating speed.
Voltage too low, coils damaged, capacitor
burnt
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a
specialist.
Arrange for replacement of the capacitor by a
specialist
Motor makes excessive
noise
Coils damaged, motor defective Arrange for inspection of the motor by a
specialist
The motor does not
reach its full power.
Circuits in the network are overloaded (lamps,
other motors, etc.)
Do not use any other equipment or motors on
the
same circuit
Motor overheats easily. Overloading of the motor, insufcient cooling
of the motor
Avoid overloading the motor while cutting,
remove
dust from the motor in order to ensure optimal
cooling of the motor
Saw cut is rough or
wavy
Saw blade dull, tooth shape not appropriate for
the material thickness
Resharpen saw blade and/or use suitable saw
blade
Workpiece pulls away
and/or splinters
Excessive cutting pressure and/or saw blade
not suitable for use
Insert suitable saw blade
Saw blade is not running
straight
a) Guide has been wrongly set
b) Wrong saw blade
a) Set the saw blade guide according to the
operating instructions
b) Select a saw blade according to the operating
instructions
Burn marks appear on the
wood during the cutting
work
a) Blunt saw blade
b) Wrong saw blade
a) Change the saw blade
b) Select a saw blade according to the operating
instructions
Saw blade jams during
cutting work
a) Blunt saw blade
b) Deposits on the saw blade
c) Guide has been set poorly
a) Change the saw blade
b) Clean the saw blade
c) Set the saw blade guide according to the
operating instructions
To Next Page
Loading...
Need help?
General
