Scheppach HF50 Translation Of Original Instruction Manual

www.scheppach.com
34
|
GB
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with designation H05VV-F.
The printing of the type designation on the connection
cable is mandatory.
Connection type M
Connection method, in which the connection cable can
be easily replaced without the aid of a special tool, us-
ing a special cable, for example with moulded bending
protection sleeve or crimped connections.
For single-phase AC motors, we recommend a fuse
rating of C 16A or K 16A for products with a high start-
ing current (from 3000 watts)!
• The product fulls the requirements of EN 61000-
3-11 and is subject to special connection require-
ments. This means that use at any freely selectable
connection points is not permitted.
• Given unfavourable conditions in the power supply
the product can cause the voltage to uctuate tem-
porarily.
• The product is only intended for use at connection
points that
a) do not exceed a maximum permissible mains im-
pedance “Z” (Zmax. = 0.241 Ω), or
b) have a mains constant current carrying capacity
of at least 100 A per phase.
• As the user, you are required to ensure, in consulta-
tion with your electric power company if necessary,
that the connection point at which you wish to oper-
ate the product meets one of the two requirements,
a) or b), named above.
13. Cleaning
m Danger!
Pull out the mains plug before all maintenance and
cleaning work.
• Keep protective devices, air vents and the engine
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it o󰀨 with
compressed air at low pressure.
• We recommend that you clean the product directly
after every use.
• Make sure that the workpiece is pressed rmly
against the stop bar.
• Push the workpiece slowly from right to left against
the direction of rotation of the cutter tool.
• Keep the feed speed constant. Do not push too fast,
this would slow down the motor too much.
• If you push too fast, you could get a poor quality cut.
This could also damage the cutter tool or the motor.
• If you push too slowly, burn marks could appear on
the workpiece.
• With very hard wood and large cuts, it may be nec-
essary to do more than one working step to achieve
the desired depth.
• The correct feed rate depends on the cutter size,
the material type of the workpiece and the cutting
depth. Practise with a piece of waste material rst to
nd the right feed speed and dimensions.
12. Electrical connection
The electrical motor installed is connected and ready
for operation. The connection complies with the appli-
cable VDE and DIN provisions.
The customer‘s mains connection as well as the ex-
tension cable used must also comply with these reg-
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.

Scheppach HF50 Specifications

General

Brand	Scheppach
Model	HF50
Category	Power Tool
Language	English