Scheppach HS105 - Troubleshooting

www.scheppach.com
GB
|
43
16. Troubleshooting
Fault Possible cause Remedy
Saw blade is loose after the
motor is switched o󰀨
Fixing nut not tight enough Tighten xing nut, right-hand thread
Motor does not start Mains fuse blown Check mains fuse
Extension cable defective Replace the extension cable
Connection to the motor or
switch not OK
Have this checked by an electrician
Motor or switch faulty Have this checked by an electrician
Incorrect motor rotational
direction
Capacitor defective Have this checked by an electrician
Incorrect connection Have an electrician transpose the wall plug
poles
Motor not supplying power,
fuse tripping
Cross section of the extension
cable insu󰀩cient
see Electrical connection
Overload due to blunt saw
blade
Replacing the saw blade
Burnt areas on the cutting
surface
Blunt saw blade Sharpen, replace saw blade
Incorrect saw blade Replace saw blade