www.scheppach.com
40
|
GB
m DANGER
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, lm and small parts! There is a risk of swal-
lowing and suocation!
• The equipment must be securely installed, i.e. bolt-
ed down on a workbench, base frame or similar. Use
the holes on the inner side of the frame legs for this.
• All covers and safety devices have to be properly
tted before the equipment is switched on.
• It must be possible for the blade to run freely.
• When working with wood that has been processed
before, watch out for foreign bodies such as nails
or screws, etc.
• Before you press the On/O switch check that the
saw blade is tted correctly. Moving parts must run
smoothly.
• Before you connect the equipment to the power sup-
ply make sure the data on the rating plate are identi-
cal to the mains data.
• Connect the equipment to a properly installed pro-
tective contact socket, with at least 16 A circuit
breaker.
9. Assembly
m WARNING: Danger of injury!
Improper installation of the circular table saw may re-
sult in serious injury.
Before commissioning, properly and completely install
the circular table saw, including all covers and safety
devices.
Never plug the mains plug into the power socket before
completing the installation.
If connections are secured with a hexagonal bolt, nut,
spring washer and washer, the washer and spring
washer must be tted under the hexagonal bolt. The
spring washer always lies directly on the (inner) hex-
agonal bolt or nut.
Hexagon screws must each be inserted from outside
inwards, and the connections must be secured from
the inside with nuts. During assembly nuts and screws
must only be tightened until hand-tight, so that they
cannot fall out. If you tighten the nuts and screws fully
before nal assembly, the circular table saw cannot be
erected in a correct and stable manner.
Noise
The t ota l noi se valu es wer e dete rmi ned i n acc or danc e wit h
EN 62841.
Sound pressure level L
pA
93,5 dB(A)
Uncertainty K
pA
3 dB
Sound power level L
WA
106,5 dB(A)
Uncertainty K
WA
3 dB
Wear hearing protection.
The eects of noise can cause a loss of hearing. Total
vibration values (vector sum - three directions) deter-
mined in accordance with EN 62841.
NOTE: The specied device emissions values have
been measured in accordance with a standardised test
procedure and can be used for comparison of one elec-
tric tool with another.
The specied device emissions values can also be
used for an initial estimation of the load.
m WARNING: The noise emission values can vary
from the specied values during the actual use of the
electric tool, depending on the type and the manner in
which the electric tool is used, and in particular the type
of workpiece being processed. Implement measures to
protect against noise nuisance. In doing so, take into
account the complete working process, including the
times when the electric tool is working without load or
switched o. Suitable measures include regular main-
tenance and care of the electric tool and the insertion
tools, regular breaks as well as proper planning of the
working process.
8. Before starting the equipment
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
To Next Page
Loading...
Need help?
General
