Scheppach ts 4020 - Precutting Device Operation

english 27
SW5
SW4
1
2
3
Precutting device for panel sizing circular saws
Abb. "U"
Important:
Do only use sharpened, faultless „original“ SCHEPPACH saw
blades
In case of an redounded saw balde change the table insert.
ATTENTION !
Pull power cable before changing the saw balde
1 holding mandrel
2 screw M8
•Removethelefttableinsert
• Putthe holdingmandrel (1)in thesawshaft throughthe
drillinginthelefttablehalf.Forunfastingorxingthescrew
(2)thesawshaftwillbexedwiththeholdingmandrel
• Take care of the running directon of the saw blade
ATTENTION! Close protection cap (5)
Risk of damage! (Picture „L“)
Fig. "V , W , Y“
the potrusion of the scoring saw balde on the table surface
modiestothecuttingbandform1,0–2mm.
Withthescrew(2)Fig„V“youwilldothehighadjustment
1rotationconforms1,5mm(Fig.„Y“)
The band of the scoring saw blade will be regulated with the
spacerwasher(A).(1x0,1mm,2x0,2mm,1x0,3mm)Fig.„W“
Theprescoringdeviceshouldhavethesamesize(band)
thanthesawbladeofthemachine,2,8mm–3,6mmare
possible.
The alignment of the scoring saw blade to the saw blade of
themachinewillbeadjustedwiththescrew(3)Fig.„V“.1
rotationconforms0,1mm(Fig„Y“)
For checking make a cut sample.
Ifthemachineisnotused,prescoringdeviceandthescrew
(2)istobedroppedunterthetable.
Fig."U"
Fig."V"
Fig."W"
0,1 mm/
1,5 mm/
Fig."Y"
A