Schiller Mantis 7566A - Page 19

18
Schiller Grounds Care, Inc. P/N 802-0006
OPERATION
SHALLOW TILLING / CULTIVATING
– Switch the tine positions from the default tilling position. (Figure 1)
To set them for tilling, attach the tines so
the points of the blades face forward - away
from the operator. The tines’ points will
contact the ground rst.
Tine
Rotation
Tine Teeth
Back
Handles
Front
TILLING POSITION
FIGURE 1
For cultivating, reverse the tines so that
the points of the tines face backward -
toward the operator. Now the long at part
of the tine’s blade will contact the ground
rst.
SHALLOW TILLING/
CULTIVATING POSITION
Tine
Rotation
Tine Teeth
Back
Handles
Front
FIGURE 2
STEPS
1. Turn off the tiller and allow to cool.
2. Push the tiller forward and allow it to rest on the front carry handle.
3. Remove the retaining pins and remove both the left and right outer tines.
4. Remove the retaining pins and remove both the left and right inner tines from the transmission axle.
D-SHAPED
HOLE
Inner Tines
Outer Tines
5. Place the right-side inner tines on the left side of the transmission axle.
6. Place the left-side inner tines on the right side of the transmission axle.
NOTE: The D-shaped hole should be visible and away from the transmission axle.
7. Install the retaining pins.
OPERATION (CONT)