Schiller Mantis 7566A - Appendix B Related Documentation; How to Reseat the Flange

24
Schiller Grounds Care, Inc. P/N 802-0006
APPENDIX B RELATED DOCUMENTATION
HOW TO RESEAT THE FLANGE
1. If you notice a gap between the bottom of the engine ange and the top of the drive shaft (Figure 1), you can reseat the ange.
FIGURE 1
2. Find and loosen the ange bolt. (Figure 2)
FIGURE 2
3. Carefully lift the engine approximately one inch and move it side-to-side in small increments to seat it back onto the hex head of
the drive shaft. (Figure 3)
FIGURE 3
4. Push the engine back onto the drive shaft and verify the original gap is corrected.
5. Tighten the ange bolt.
FLANGE
GAP
FLANGE
GAP
FLANGE
BOLT
DRIVE SHAFT
HEX HEAD
NO FLANGE
GAP
NO FLANGE
GAP