28
Schiller Grounds Care, Inc. P/N 802-0006
APPENDIX B RELATED DOCUMENTATION
CORRECTIVE ACTION
FOR OVERFILLED OIL
If you suspect the engine oil is overlled, the following procedure should remove the excess oil. The excess oil must be pumped
out as the engine runs and cannot be removed by simply pouring out of the oil ll opening. Checking the oil level and draining any
excess between multiple 30-second running intervals will bring the oil back to the proper level.
1. Place the engine on a level surface resting at on the front carry handle and remove the oil ll cap/dipstick. Use a catch basin for
any oil that overows from the oil ll opening.
DIPSTICK
2. Replace the oil ll cap / dipstick, position the machine in an upright position, and run the engine for approximately 30 seconds
then repeat step one. Continue steps 1 & 2 until oil no longer overows when the oil ll cap/ dipstick is removed.
3. Once the oil level is corrected, the engine may continue to smoke while running for several minutes while the residual oil burns
off.
To Next Page
Loading...
