Schindler 3100/3300/6300 J 43402603 / 01 100/269
Copyright © 2017 INVENTIO AG
0012
ELEVATOR NOAUTHORIZATION MODE
The elevator is blocked because no or an invalid SIM card is inserted at the
elevator main control board (PCB).
C1:No SIM card, no Schindler SIM card, a SIM card of another elevator or
a manipulated SIM card is inserted
A1:Check if SIM card is present or if a invalid SIM card is inserted. Check
error log for SIM card errors (#19xx). Get the correct SIM card.
0017
ELEVATOR REVISION NUMBERS DO NOT MATCH
C1:SIM card available, but internal COMM number doesn't correspond
with the one stored in the SCIC EEPROM. Wrong SIM card delivery or
SCIC already used in another elevator.
A1:Replace with SIM card that is dedicated (specially configured) for this
installation. Install SCIC <=> SIM card combination that is foreseen for
this installation.
0018
ELEVATOR CHIP CARD DATA INTEGRITY FAILURE
C1:The SIM card could be read but the data is corrupt (wrong file length,
crc etc.)
A1:Change the SimCard.
0019
ELEVATOR WATCHDOG RESET
Indicates that a watchdog reset (initiated by hardware or software watchdog)
has been performed previously. The elevator main control has just started up.
C1:A main controller software internal problem has occurred
A1:Update main controller with new software release (Only if advised by
R&D. Get in contact with Locarno before.)
0020
ELEVATOR S CHAIN BRIDGED PERMANENT
Safety circuit not opened at the time when expected to be opened (for
example, while opening door)
C1:The safety circuit is bridged (for example, at the car or landing door)
A1:Check safety circuit for bridges (for example, plugs) and remove them
0021 ELEVATOR CAR CONTROLLER RESET
Elevator car controller reset
0022
ELEVATOR CAR CONTROLLER RELEVELING FAIL
A1:Check: SUET
0023
ELEVATOR ISK FAIL ON PREOPEN
*)
This error is not used anymore with actual SW
0024
ELEVATOR KNE U INTERRUPTED
C1:The car has exceeded the hoistway end limit (for example, KNE_U)
A1:Check why the car has exceeded the hoistway end limit. Check log for
possible previous reported messages. Release elevator from blocked
state (perform reset procedure)
C2:Safety circuit wiring faulty or safety circuit contact(s) defective or bad
adjusted
A2:Check general wiring safety circuit and safety circuit contacts at
corresponding safety circuit section
0025 ELEVATOR ISK PREOPEN ERROR
*)
0027 ELEVATOR CC RELEVELING FAIL FATAL *)
Code General Message
To Next Page
Loading...