Why does Schlage AD-300/ AD-302 door lock not grant access immediately?
The delay in granting access is managed by the access control panel. You should verify the configuration of the access control panel to resolve this issue.
What to do if Schlage AD-300/ AD-302 door lock is not communicating with the access control panel?
If the Schlage button blinks red once, or the IPB LED blinks red four times with rapid beeps, it indicates a communication problem. Ensure the RS485 Communication Module is correctly installed and fully seated without any bent pins. Also, verify that the lock is properly wired to the access control panel and that the access control panel software is correctly configured for the AD-300/AD-302 door. For a 993 exit trim, confirm the Request To Exit switch is installed.
General| Brand | Schlage |
|---|---|
| Model | AD-300 |
| Type | Electronic Deadbolt |
| Power Source | Battery |
| Lock Type | Deadbolt |
| Keyway | Schlage C |
| ANSI Grade | Grade 2 |
| Access Method | Keypad |
| Backset | 2-3/8 inch or 2-3/4 inch |
| Battery Type | 4 AA |
| Handing | Reversible |
Explains creating a master construction credential for card readers to manage access.
Step-by-step guide to manually setting the RS485 address without RS485 communication.
Resets configurations and settings in the main controller, but not the reader.
Resets all configurations and settings in both the lock and the reader.
To Next Page
