2 • Schlage • AD-400 user guide
Contents
Overview ........................................................................................................................... 3
Getting started
..................................................................................................................4
Schlage Utility Software (SUS)
.........................................................................................4
Optional inside push button (IPB)
.....................................................................................5
User management
............................................................................................................5
Construction access mode
...............................................................................................6
Locks with keypads – Construction access mode.........................................................6
Locks with card readers – Create a master construction credential .............................6
Locks with card readers – Add construction access mode user credentials ................. 7
Cancel construction access mode ................................................................................7
Link to a PIM400
............................................................................................................... 8
Link LED and beep reference .......................................................................................8
Test lock operation
............................................................................................................ 9
Mechanical test .............................................................................................................9
Electronic test................................................................................................................9
Reset to factory default settings
.....................................................................................10
Level 1 factory default reset ........................................................................................ 10
Level 2 factory default reset ........................................................................................ 10
Communication properties
.............................................................................................. 11
Communication failure
.................................................................................................... 11
Batteries
..........................................................................................................................12
Installing or replacing batteries ...................................................................................12
Low battery indications................................................................................................12
Battery failure modes ..................................................................................................13
External power supply
....................................................................................................13
LED and beep reference
.................................................................................................13
Troubleshooting
..............................................................................................................14
FCC/IC statements
.........................................................................................................15
To comply with FCC and Industry Canada RF radiation exposure limits for general population, the
antenna(s) used for this transmitter must be installed such that a minimum separation distance of
20 cm is maintained between the radiator (antenna) and all persons at all times and must not be
co-located or operating in conjunction with any other antenna or transmitter.
This product is compliant of UL294 and ULCS319 standard. This product’s compliance would be
invalidated through the use of any add-on, expansion, memory or other module that has not yet been
evaluated for compatibility for use with this UL Listed product, in accordance with the requirements of
the Standards UL294 and ULCS319. This product has been evaluated for ULC-S319 Class I.
To Next Page
General
