Schmalz VSi Series User Manual

MANUAL OPERATION OF THE DISPLAY VERSION
30.30.01.00956/01 www.schmalz.com EN | 21
6.1.4 Entering the PIN code
If the menu was write protected with a PIN code, this must be entered first before a parameter can be
changed. If you attempt to change a value, the message “P.l.n” will appear in the display and changes
after two seconds to enter the 3-digit PIN code. This will be entered number by number like any other
numerical value and confirmed with the MODE button.
When entering a valid PIN the message “UnC” appears and any number of parameters can then be
changed. It is also possible to quit the menu in the meantime. If no button has been pressed for one
minute or the switch was switched on or off, write protection is activated again.
The entry of an invalid PIN is rejected with the message “LoC.”
6.1.5 Automatically quitting the menu
The menu will automatically close if no button is pressed for one minute.
The display also returns to the basic status when an error status occurs so that the error number can
be displayed. The menu can be called up and used again afterward.
If parameters are changed using one of the other interfaces, i.e. via the IO-link or NFC, the menu will
also close. The instruction “dAt” will then appear for two seconds.

Schmalz VSi Series Specifications

General

Brand	Schmalz
Model	VSi Series
Category	Switch
Language	English