Maintenance
08.00 | MPG-plus | Assembly and operating manual | en | 0389216
41
7 Maintenance
7.1 Notes
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
Exchange of housing and base jaws
The base jaws and the guidance in the housing are matched. To ex-
change these parts, send the product with a repair order to
SCHUNK.
Maintenance of version with gripping force maintenance I.D.
gripping and O.D. gripping
The pistons have to be aligned using an assembly device. There-
fore we recommend to have the module serviced and the seals re-
placed by SCHUNK.
7.2 Maintenance and lubrication intervals
NOTICE
Damage caused by insufficient lubricant!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
• Reduce the lubricant intervals accordingly.
MPG-plus
16 - 20 25 - 32 40 - 50 64
Interval [Mio. cycles] 15 5 4 3
7.3 Lubricants/Lubrication points (basic lubrication)
SCHUNK recommends the lubricants listed.
During maintenance, treat all greased areas with lubricant. Thinly
apply lubricant with a lint-free cloth.
Lubricant point Lubricant
Cross roller guide microGLEIT GP 360
All seals Renolit HLT 2
To Next Page
Loading...
Need help?
General
