Schweizer S300CB - Page 80

Normal Procedures
Pilot's Flight Manual
4-6 Reissued: 16 Jan 2019
TAIL ROTOR (cont)

2. Tail rotor blade pitch links, teetering
bearings, and swashplate CHECK
CAU TION
If poor abra sion strip bond is sus pected, but not con -
firmed, in spect blade in ac cor dance with HMI prior to
further flight.
3. Tail rotor abrasion strip bonding CHECK
CAU TION
If tail rotor blade at tach ment bushing hole cracking is
sus pected, per form dye penetrant in spec tion in ac cor -
dance with HMI prior to further flight.
4. Tail rotor blade attachment bushing hole for
evidence of cracks CHECK
5. Tail rotor push-pull rod CHECK
6. Tail skid CHECK
7. Tail rotor transmission/oil level CHECK
8. Horizontal stabilizer, vertical fin, and tail
light CHECK
TAILBOOM, RIGHT SIDE

1. Tailboom for damage or dents CHECK
2. Tailboom supports and fittings for cracks,
looseness, security, deformation, or damage CHECK
3. Tailboom support strut end fitting for cracks,
deformation, or damage CHECK
SCHWEIZER
Model 269C-1 Helicopter
FAA Approved
CSP book 2..indd 80 8/4/19 12:53 PM