Schwing VECTOR User Manual

Service Manual
52 VECTOR CONTROLLER-SERVICE MANUAL
Step 2
After outriggers are extended the display will tell you
to jack them.
NOTE!
By pushing the “START“ button the
operator is confirming that all outriggers
are supporting the unit properly.
For roll & fold™ units There are no further steps.
The assistant is finished now and the Display shows the
normal Vector screen.
With the roll & fold™ boom it is now safe to operate in
the selected working area
Step 3
The assistant explains that boom #1 & #2 should now
be extended VERTICAL ONLY!
During this step all other boom functions are disabled.
NOTE!
Cab protection is still active.
Step 3b
The system recognizes that boom #1 is vertical but the
operator must now confirm that #2 is vertical as well.
Push the “START“button to confirm that
both booms are vertical.
OK
EASy Assistant
Is the unit
supported
by all
outriggers?
-> [START]
S
Figure 47
Outriggers supported screen.
vectornormal.eps
1
0
2
3
PTO
Menu: [ENTER]=ON
1760 rpm
x1000
Start
52˚C
Figure 48
Normal operation screen
OK
EASy Assistant
Extend
Boom 1 & 2
VERTICAL
only!
Figure 49
“Extend vertical only” screen
OK
EASy Assistant
Are boom
#1 & #2
vertical?
-> [START]
S
Figure 50
“Are boom #1 & #2 vertical?” screen
start.eps
START

Schwing VECTOR Specifications

General

Brand	Schwing
Model	VECTOR
Category	Control Systems
Language	English