Schwinn 170 - Assembly Steps; Attach Stabilizers to Main Frame; Install Console Mast, Mast Gasket and Top Shroud

8
assembly
1. Attach Stabilizers to Main Frame
Note: Hardware(*) is pre-installed on the stabilizers and not on Hardware Card. Make sure transport wheels on the
front stabilizer point forward, and the Schwinn
®
decal on the rear stabilizer faces outward from the machine.
2. Install Console Mast, Mast Gasket and Top Shroud on Main Assembly
NOTICE: Make sure the Console Cable connector (a) does not fall into the Console Mast. Align the clips on the cable
connectorsandmakesuretheconnectorslock.DonotcrimpConsoleCable.BesurethetabsontheTop
Shroud snap into the Main Assembly.
X2
X2
6 mm
6 mm
*
*
*
*
*
*
6
5
4
A
6 mm
C
B
X4
a