Page 6
637-8808 Rev. J
NOTE: If a torque wrench is not available, please
skip to Step 4.
4. Close the fore/aft adjustment lever, then use
a torque wrench with a 11mm deep socket
to tighten the fore/aft lever adjustment nut
to 3 Nm (2.21 Ft-Lbs). This will conclude the
procedure.
5. With the fore/aft adjustment lever up, tighten
the adjustment lever nut 1/4 of a turn, then
close the adjustment lever and check the
function by pushing backwards on the
handlebars - they SHOULD NOT move.
6. Repeat Step 4 as needed until the handlebars
are tight. This will conclude the procedure.
Fig. 9
To Next Page
Loading...
