EasyManuals Logo

SCOTT Eagle Attack User Manual

SCOTT Eagle Attack
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
P/N 595224-01 Rev E 7/12Page 26 of 32
CAUTION
REGULARLY INSPECT THE EAGLE ATTACK THERMAL CAMERA AND CHARGING
SYSTEM FOR LOOSE, WORN, OR DAMAGED COMPONENTS. IF ANY DAMAGE IS
FOUND, REMOVE THE UNIT FROM SERVICE AND TAG FOR REPAIR BY AUTHORIZED
PERSONNEL.
REGULAR INSPECTION
Routinely inspect the EAGLE ATTACK Thermal Imaging Camera and Charging System
for signs of wear or damage.
Check the camera housing, handle, display, and lens for cracks, scratches or other
damage that interferes with the performance of the camera.
Verify that all fasteners and mounting hardware are present and tight.
Verify that all rubber boots are present and in good condition with no cuts, tears,
or loose pieces. Verify that the boots are fully installed and properly seated.
Verify that the battery is undamaged and shows no signs of leakage.
Check the optional ashlight assembly and bracket for damage.
Check the optional camera lanyard for weakness or damage.
Check all battery contacts. The contacts must be clean and undamaged. Spring
loaded contacts must be straight and move without sticking.
If any loose, worn, or damaged components are found, remove the EAGLE ATTACK
Thermal Camera from service and tag for repair by authorized personnel.
Regularly inspect the EAGLE ATTACK CHARGING SYSTEM for worn or damaged
components.
Verify that all fasteners and mounting hardware are present and tight.
Check all battery contacts. The contacts must be clean and straight. Spring loaded
contacts must be straight and move without sticking.
Check housing cradle and base for cracks or other damage
Check the two (2) hold down straps for tears or cracks which might cause a failure
of the strap.
Verify that all electrical connections are secure and properly protected.
If any loose, worn, or damaged components are found, remove the EAGLE ATTACK
CHARGING SYSTEM from service and tag for repair by authorized personnel.
If any damage is found that is beyond the scope of these instructions, contact an
authorized SCOTT Safety service center for assistance.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SCOTT Eagle Attack and is the answer not in the manual?

SCOTT Eagle Attack Specifications

General IconGeneral
BrandSCOTT
ModelEagle Attack
CategoryThermal cameras
LanguageEnglish