P/N 595224-01 Rev E 7/12Page 7 of 32
Keep the lens clean while operating the thermal imaging camera.
• Dirt or soot build up on the lens will obscure or reduce the clarity of the thermal
image. Wipe the lens with a glove or cloth as needed. Clean the lens thoroughly
after use.
• Condensation on the lens of the thermal imaging camera will also block the thermal
image and make entire display appear blank. Wipe the lens regularly to remove
accumulated condensation. Use an approved anti-fog preparation on the lens
to reduce the possibility of condensation on the lens.
SEE THE WARNINGS ON PAGES TWO AND THREE OF THIS INSTRUCTION
To Next Page
Loading...
Need help?
General