You have 3 positions of the TWINLOC remote lever.
1. LOCK OUT MODE:
the shock is locked; climbing on asphalt roads is now possible without any power
loss. Simultaneous a blow-off-system prevents the shock being damaged in case the
rider did not open the system while crossing obstacles.
2. TRACTION/RIDE MODE:
For Traction: by reducing the internal chamber volume inside the shock the travel of
the shock will be reduced to around 80% (approx. 120/104mm) the characteristic of
the air spring gets harder, the SAG is shorter and the geometry steeper. This results
in climbing without “bobbing” and offers still optimum traction of the rear wheel.
For Ride: by adding a platform on the compression damping system the shock will
not bounce while standing on the pedals
3. DESCENT MODE:
full travel of 150/130mm (27. 5”/2 9”)
You will find the following positions on the remote lever:
For the assembly of the remote control of the front fork lock-out 2 different cable
rolls which are changeable are existing.
The different roll for the pull of the fork remote cable can be changed within few
minutes to adapt the lever to your fork model/brand.
You will see on the downside of the roll the indication of the fork brand or the
fork model.
SCOTT offers 2 different TWINLOC levers with following fork/rear shock
combinations:
- FOX Nude with different rolls for FOX CTD fork and RockShox DNA 3 fork (SCOTT
Article number: 230097)
- FOX CTD with different rolls for FOX CTD fork and RockShox DNA 3 fork (SCOTT
Article number: 230098)
Please kindly note that the cable roll of a RockShox DNA3 or FOX CTD fork-lever
is not interchangeable with the regular rolls of 2 step forks. You need to use
another lever!
For more details please contact your authorized SCOTT dealer.
To change the rolls to match another fork brand pls follow the drawings below:
ROLL FORK MOUNTING
ROLL FORK UNMOUNTING
To Next Page
Loading...
Need help?
General
