11
English
CHROMIS USER MANUAL
Dual time uses the same “base time” as the
main clock. Therefore, adjusting the time as
described in chapter Setting the time and
24h or AM/PM mode, will also infl uence
the dual time. The Dual time zone selection
will defi ne the difference to the main clock
time. When the time zone selection is OFF,
then the Dual time is disabled.
When pressing the SEL button the UTC2
time hours start blinking. You may change
the setting by pressing + or – buttons in a
range of +14h..-13h or off. By pressing the
SEL button, the minutes will start blinking
and you may edit them using + or – buttons
in 15 minute intervals. The UTC2 setting will
be confi rmed by pressing the SEL button.
3.1.5 Setting the date
When in the date setting, press the SEL
button and the blinking digits can be
changed by pressing + or – buttons (in
24h mode the fi rst digit are days, in 12h
mode the month is fi rst). By pressing the
SEL button the next digits start blinking and
they may then be edited by pressing + or –
button. Again, by pressing the SEL buttons,
the year, after the dot, starts blinking. The
date will be confi rmed by pressing the SEL
button.
3.1.6 Setting the sound off
(silent mode)
ON/OFF/ALR (with ALR: alarm and
attention sound during diving are enabled)
By pressing the SEL button the current
setting will start blinking at the middle of the
display. By pressing + or – buttons you may
select between the normal mode, where
alarm and button tones are on, or the silent
mode, where all tones are off, or alarm mode
where only alarm tones are on (ALR). The
sound off selection is protected with a code.
When sound off has been selected the
fi rst digit starts blinking. By pressing + or
– buttons the number can be changed and
by pressing the SEL button the number will
be stored.
The unlock code for sound off is: 313.
To Next Page
Loading...
Need help?
General
