Operation & Maintenance Manual──LG958L/LG959 Wheel Loader
75
1000~1200r/min gradually, and then enter the partial load running status. Pay attention to the
value of the gauge.
z Do not let the engine run at high speed or low speed more than 20 minutes in the idle status.
z If the engine has to run at idle status, the machine should be loaded from time to time or the
engine should run at the middle speed.
3.3 Running
3.3.1 Driving
Make sure there is no other person in, on or around the
machine or around to prevent accident. And keep the
machine under control.
z Raise the lift-arm. Keep the bucket backwards, and
keep the motor running.
z Put the gear control lever at forward I or reverse I
position.
z Press the brake pedal; rotate the parking brake
switch to release the brake status.
z Release brake pedal, and step on the accelerator
pedal slowly to drive the machine forward or
backward.
z It is safe to drive only when the brake pressure is over the specific value of 0.45MPa.
z Never lift the bucket to the highest position while transporting material. The lower hinge of the
arm working equipment should be 400～500mm above the ground to ensure stable driving in the
transporting process.
To Next Page
Loading...
Need help?
General
