Operation & Maintenance Manual──LG958L/LG959 Wheel Loader
80
z Raise the lift arm to prevent the bucket from inserting too deeply while thrusting the bucket into
the material. The tires will bring ample traction by raising the lift arm.
z If enough material is loaded into the bucket, operate the
working equipment control lever to take back the bucket in
order to load it fully.
Remark:
If the shovel edge moves up and down when thrusting material into
the bucket or when digging, the front tires will leave the ground and slip.
z If there is too much material loaded into the bucket, the bucket must be dumped and titled quickly
to remove the excessive load so as to prevent the material from dispersing during transportation.
Digging and Shoveling Material on Flat Ground
Lightly set the bucket edge leaning on the ground (see
picture) when digging and shoveling material on flat ground.
Be careful not to fasten the load to one side which will cause
unbalance. This operation should be carried out carefully
in gear .Ⅰ
z Lightly set the bucket edge facing down.
z When driving the machine forward, operate the working
equipment control lever to let the lift arm lower down to the proper position so that it can pick up
a thin layer of the surface each time when excavating the
soil.
z When driving the machine forward, shift the working
equipment control lever backward and forward slightly to
reduce the resistance.
△
! NOTICE
Keep the two sides of the bucket cutting into the material equally
to prevent only a single side working. Face the loader forward and
never let an angle exist between the front and rear frame.
(3) Conveying Operation
To Next Page
Loading...
Need help?
General
