Erasing fault codes
The memory of the diagnostic function is reset when
the power to the engine is disconnected.
When the power is switched on again the diagnostic
function will check if there are any malfunctions in the
system. If so a new fault codes is registered.
NOTICE! Power must be disconnected completely.
This means that fault that hasn’t been corrected:
1 are shown as active,
the active fault code can then
be erased with the VODIA tool.
2 must be acknowledge and read out every time the
engine is switched on.
If the diagnostic button is depressed after the fault has
been corrected and fault code deleted, the code 1.1,No
fault, will show.
Fault Handling
7748681 12-2011 35
To Next Page
Loading...
