7.9
SECTION 7 • OPTIONS & ACCESSORIES
220 Select
area. On the bottom edge of the Windshield
Visors and Side Curtains you will notice the
snapless rubber extrusion. The extrusion fits
into the top of the windshield frame. To ease
the installation of the extrusion, remember to
partially zip the windshield Visor and Side
Curtains to relieve tension.
B. TRAILERING WITH CANVAS
To trailer your boat with the cockpit cover installed,
you must install a mooring cover over the cockpit
cover with tie down straps tightened. The Bimini
Top, side curtains and rear (aft) cover, however,
must be removed when trailering. Damage will
occur to canvas and to the metal rods (bows) or
boat if attached to boat while trailering.
C. CANVAS CARE AND MAINTENANCE
See Section 9, page 9.2, for instructions on the care
and maintenance of your canvas.
17. DOCKING LIGHTS (OPTIONAL)
The optional docking lights are protected by the
ACCY SW fuse on the accessory fuse block (see
Fig. 6.5.2). They are operated by pressing the
ACCY switch on the control station switch panel
(see Fig. 6.5.4).
SNAPLESS EXTRUSION
(FIG.7.8.1)
WINDSHIELD FRAME
WITH SNAPLESS CANVAS
EXTRUSION
INSERT TOP SNAP IN BOTTOM
To Next Page
Loading...
