14
DAT 72/DDS-4 Product Manual
Regulatory Compliance
The DAT 72 and DDS-4 drives comply with the regulations listed in the following
table.
1.
Required compliance for external model; verification on file for internal models.
Use these drives only in equipment where the combination has been determined to
be suitable by an appropriate certification organization (for example, Underwriters
Laboratories Inc. or the Canadian Standards Association in North America). You
should also consider the following safety points:
•
Install the drive in an enclosure that limits the user’s access to live parts, gives
adequate system stability and provides the necessary grounding for the drive.
•
Provide the correct voltages (+5 VDC and +12 VDC) based on the regulation
applied—Extra Low Voltage (SEC) for UL and CSA and Safety Extra Low
Voltage for BSI and VDE (if applicable).
To Next Page
Loading...
