Sealey Auto Service Series Instructions

Page 2
IMPORTANT: Failure to understand and follow the instructions listed below
may result in electric shock, re and/or serious personal injury.
1.1. Work Area Safety
1.1.1. Always perform automotive testing in a safe environment.
1.1.2. Ensure that work area is clean and well lit.
1.1.3. Keep clothing, hair, hands, tools, test equipment, etc. away from all moving or
hot engine parts.
1.1.4. Operate the tool in a well-ventilated work area.
1.1.5. DO NOT operate the tool in explosive atmospheres.
1.1.6. Ensure that a suitable re extinguisher is available.
1.1.7. DO NOT use the tool around corrosive chemicals which can damage the tool.
1.1.8. Keep unauthorised personnel and children clear of the work area whilst
operating the tool.
1.1.9. Keep the tool dry, clean, free from oil, water and grease. Use a mild detergent
on a clean cloth to clean the outside of the tool when necessary
1.2. Electrical Safety
1.2.1. Avoid body contact with earthed or grounded surfaces such as pipes, radiators,
ranges and refrigerators.
1.2.2. DO NOT expose the tool to rain or wet conditions. Water entering the tool will
increase the risk of electric shock.
1.2.3. DO NOT abuse the cable. Never use the cable for carrying, pulling, or
unplugging the tool. Keep cable away from heat, oil, sharp edges or moving
parts.
1.3. Personal Safety
1.3.1. DO NOT use the tool while tired or under the inuence of drugs, alcohol, or
intoxicating medication.
1.3.2. DO NOT over-reach. Maintain proper footing and balance at all times.
1.3.3. DO NOT place the tool on any unstable surface. The tool may fall, causing
injury to a person or damage to the tool.
1.3.4. Never spill liquid on the display unit.
1.3.5. DO NOT use the tool for personal or medical use in any way.
1.3.6. The product is not shock resistant. DO NOT use it as a hammer or drop it.
1.4. Battery Safety
1.4.1. Remove the battery while cleaning the tool.
1.4.2. Remove the battery before storing the tool for a long period of time to prevent
battery leakage from damaging battery compartment.
1.4.3. When necessary, replace all four (4) batteries with new ones.
1.4.4. Use only the size and type of batteries specied.
1.4.5. Be sure to install the batteries with the correct polarity as indicated in the
battery compartment.
1.4.6. Dispose of batteries according to local authority guidelines. DO NOT dispose of
batteries in re.
1. SAFETY INSTRUCTIONS
© Jack Sealey Limited 2012

Sealey Auto Service Series Specifications

General

Brand	Sealey
Model	Auto Service Series
Category	Measuring Instruments
Language	English