Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycle centre and
disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling information.
Battery Removal.
Open the rear cover as in 3.1.
Remove the batteries.
Replace the cover.
Dispose of batteries according to local authority guidelines.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are
required to inform potential purchasers of products containing batteries (as defined within
these regulations), that they are registered with Valpak’s registered compliance scheme.
Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705
5. TROUBLESHOOTING
SYMPTOMS POSSIBLE CAUSE SOLUTION
Display is on, but does not
show image
Cable connection is loose Check and reattach
Imager head lens is dirty Check and clean as
necessary
LED on imager head is
dim at max brightness,
display changes between
monochrome and color,
display turns itself OFF
after a short period
Low battery Replace battery
The tool will not turn on Dead battery Replace battery
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500.
To Next Page
Loading...
