Page 8
3.1.3. Remove the battery compartment (g.5) and remove the batteries.
Note: Dispose of used batteries in accordance with local regulations.
3.1.4. Install the new batteries ensuring that the correct polarity is observed.
Note: When replacing the batteries, replace all four at once.
3.1.5. Ret the battery compartment into the handle. Slide on the battery compartment
cap and secure with the screw.
3.2. Imager Head and Cable Installation
3.2.1. To use the tool, the imager head and cable must be connected to the display
unit. To connect the cable to the display unit, make sure the key and slot (g.6)
are properly aligned. Once they are aligned, nger-tighten the knurled knob to
hold the connection rmly in place.
3.3. Accessories Installation
3.3.1. The three accessories include magnet, hook and mirror (g.2). All are attached
to the imager head in the same manner. Hold the accessory and the imager
head as shown in g.7.
g.5
g.6
© Jack Sealey Limited 2012
To Next Page
Loading...
Need help?
General
