28
SeaStar ProTap Controller
CAN Bus
Connectors
Tee Connectors:
Supplied by several vendors. Appearance may vary – parts
are interchangeable.
Note regarding connectivity of tee connectors:
• When connecting a tee connector to a component
always install via the middle connection (“NODE”).
• When connecting a tee connector to a CAN Bus
harness to connect components that are far from
each other, always install via the male/ female end
of the connector (whichever applies).
• Hand-tighten after the connection is made. DO NOT
tightly tie down the tee connectors, as this will
create stress.
BACKBONE
MALE FEMALE
NODE IS ALWAYS FEMALE
Figure 9-2.
Figure 9-3.
CM10051:
MALE TERMINATOR
CM10052:
FEMALE TERMINATOR
To Next Page
Loading...
