Seastar Solutions Seastar PROTAP Controller User Manual

1
Installation Instructions and Owner's Manual
2.0 SAFETY INFORMATION
The safety information provided below is intended to
inform you of the dangers that may be present before,
during and after the installation. It is critical that you
read and understand ALL the points noted.
The safe operation of the controller is dependent upon
proper installation and maintenance, common sense,
safe judgment and the knowledge/expertise of the
operator. Every installer/user of the controller should
know the following requirements ‘before’ installing/
using the controller.
If you have any questions regarding any of these
warnings, contact SeaStar Solutions.
To reduce risk of severe injury or death. Always wear a
Coast Guard Approved personal flotation device (PFD)
and use an engine shut-off cord (lanyard).
1. Read and understand the Installation and Owner’s
Manual provided with your controller.
2. Ensure that all components required to complete the
installation are on hand (including wires, terminals
and the proper tools required for the installation).
3. SeaStar components are highly engineered and
safety tested to ensure system integrity, DO NOT
substitute any component with non-SeaStar
components as this may compromise system
performance/reliability.
1. Install the controller and the components that
connect to the controller as directed in appropriate
Installation Manuals.
2. DO NOT modify or substitute any component in any
way without written consent from SeaStar Solutions.
3. Comply with all system ratings/regulations (boat/
engine, U.S.C.G.).
4. Confirm that there is no interference between the
steering cylinder(s), tiebars and the transom, splash-
well, outboard engine or Jackplate or any combination
of these parts by performing the following steps;
a) With engine fully tilted DOWN, turn steering wheel
from hard over to hard over and confirm that no
interference occurs.
- if using a hydraulic jack plate the above must also
be performed at all the positions of the Jackplate.
b) Repeat step 'a' with engines tilted UP.
c) Perform step 4a) with each engine in DOWN/UP
positions confirming that independent TRIM/TILT
can be done without any interference.
2.1 General
Before installation
Installation
WARNING
WARNING

Seastar Solutions Seastar PROTAP Controller Specifications

General

Brand	Seastar Solutions
Model	Seastar PROTAP Controller
Category	Boating Equipment
Language	English