QUICK START GUIDE
SEAWARD PG 5
IMPORTANT INFORMATION
Intended Use / Use for Intended Purpose
The instrument is designed for the purpose of performing specific electrical tests on
portable appliances.
The instrument can be used to perform the measurements described in this manual,
which must not exceed the electrical specifications in the chapter “Technical Data” on
page 20.
Safety of the operator, as well as that of the instrument, is only assured when it is used
for its intended purpose.
Use for Other than Intended Purpose
Using the instrument for any purposes other than those described in this Quick Start
Guide, or the manual, is contrary to use for intended purpose.
Liability and Guarantee
Seaward Electronic Limited assumes no liability for property damage, personal injury
or consequential loss resulting from improper or incorrect use of the product, in
particular due to failure to observe the product documentation. Furthermore, all
guarantee claims are rendered null and void in such cases.
Nor does Seaward Electronic Limited accept any liability for data loss.
Opening the Instrument / Repairs
The instrument may only be opened by authorised, trained personnel in order to
ensure flawless, safe operation and to assure that the guarantee is not rendered null
and void. Even original replacement parts may only be installed by authorised, trained
personnel.
When the instrument is opened, voltage conducting parts may be exposed. The
instrument must be switched off and disconnected from the measuring circuit before
performing repairs or replacing parts (including the battery and fuses).
Unauthorised modification of the instrument is prohibited.
If it can be ascertained that the instrument has been opened by unauthorised
personnel, no guarantee claims can be honoured by the manufacturer with regard
to personal safety, measuring accuracy, compliance with safety measures or any
consequential damages.
If a guarantee seal is included and it has been damaged or removed, all guarantee
claims are rendered null and void.
For repair, please see details in section ‘Service and Calibration’.
To Next Page
Loading...
