Seca 264 - Installing the Foot Mat; Positioning the Device in the Wall Brackets

Before you get started … • 55
English
Positioning the device
in the wall
brackets
To position the device in the wall brackets, proceed as
follows:
1. Position the device with the slot bolts in the wall
brackets.
2. Use a spirit level to perpendicularly align the device.
3. Tighten the grub screws of the wall brackets.
4. Ensure that the heel stop is on the floor. If not, re-
adjust the slot bolts.
Installing the foot mat To install the foot mat, proceed as follows:
1. Lift up the heel stop on one side.
2. Position the foot mat under the heel stop so that
the anti-slip mat is located exactly under the hole of
the heel stop.
3. Release the heel stop.
The anti-slip mat sits in the hole of the heel stop.
4. Lift up the heel stop on the other side.
5. Swing the foot mat under the heel stop so that the
anti-slip mat is located exactly under the hole of the
heel stop.
6. Release the heel stop.
The anti-slip mat sits in the hole of the heel stop.
The foot mat is secured against slipping.