Operate head slide • 59
10. Use the arrow key (hold/zero) to enter the length of
the object.
11. Confirm the set value with the Enter key (send/
print).
The device is calibrated. You can perform height
measurements with the device.
5. OPERATE HEAD SLIDE
5.1 Measure height
Start measuring height 1. Press the Start key of the head slide.
“----” appears in the display.
NOTE
If you want to transmit the measured result to
receivers from the
seca 360° wireless system,
ensure that the receivers are switched on.
2. Keep the brake button pressed and move the head
slide until a length value appears in the display.
3. Hold down the brake button and push the head
slide up far enough so the patient can get under it
comfortably.
4. Ask the patient to step under the head slide.
– Back towards the head slide
– Heels against the heel stop
– Back and head straight
5. Hold down the brake button and push the head
slide down until it is in contact with the patient’s
head.
6. Pull the Frankfurt measure out of the head slide.
To Next Page
Loading...
