Seca 644 Series - 5 Software intended Purpose; 5.1 Installation and Start

Software seca
14.11.12/RLEU/ARI/MRE 30/40 30-34-00-812c
5 Software intended Purpose
The radio modules of the devices with NEC2 electronics
[374|376|378|703|704|284|285|634|635|644|645|656|657|664|665|674|675|676|
677|684|685|954|957|959|963] as well as the seca 360° wireless USB adapter
[456] contain software to control wireless communications. This software can be
updated using the Windows-based "seca wireless updater" program. Removing
or replacing the radio modules is generally not required.
The Windows program "seca wireless updater" has three functions:
 The configuration of the selected wireless group is displayed.
 A set-up process can be performed.
 The software in the radio modules or in the wireless USB adapter can be
updated.
Updating a wireless USB adapter takes approximately 30 seconds, updating a
radio module in a device can take up to five minutes, depending on the quality
of the wireless transmission, but typically takes 1.5 minutes.
.
5.1 Installation and Start
The seca wireless updater is
installed on a service PC or
notebook using a Windows
installation program (Setup). The
latest version of the radio module
software is copied to the PC
together with the installation.
You can display the version
numbers of the PC software and the
radio module software installed on
the PC. To do so, select the menu
item “Help” - “About wireless
updater”. Example: