Seca 644 Series - 1 Baseframe; 1.1 Replacing the NEC2 weight module

Replacement
seca 644, 645
05.02.13/MRE 4 30-34-00-857_E1
1 Baseframe
Please be sure to observe the sequence listed below when removing/fitting the parts!
1.1 Replacing the NEC2 weight module
 Detach the plug-in connection (A) of the modular cable. Release the four screw
connections (B) on the weight module housing (C) and take off the
cover (D).
 Unsolder the connection to the NEC2 weight module (F). Undo the screw connections
(E) of the weight module.
Proceed in the reverse order for reassembling.
When reassembling refer to cabling diagram 08-02-06-058.
Figure 1: Replacing the weight module
B
A
C
B
E
D
F