Seca 664 - Adjusting Feet Removal; Platform Dismantling Procedures; Castors and Left-Hand Rail Removal; Right-Hand Rail Removal

Service Manual Replacement instructions
19.08.04/Rei 3 30-34-00-673 d
Warning: Carefully thread the load cell cable out of the frame tubes. (For unsoldering see 2.1.1).
Remove the spacer disks (Item 6.5) and the screws (Items 6.6, 6.7). Warning: The longer screws
(Item 6.7) are used to screw the load cell cover tight.
2.4 Removing the adjusting feet (Page 6)
Screw out the complete foot (Items 6.14, 6.15) and screw off the knurled nut (Item 6.15).
3. Dismantling the platform
If required: Remove the cable gland (Item 7.13).
First of all, remove the ferrite from the cable of the mains socket (Page 8). Then pull out the cables
of the load cells and the mains socket.
3.1 Removing the castors and the left-hand rail (Page 9)
Release the 4 screw couplings (Item 9.1).
Remove the castors (Item 9.2), the backplates (Item 9.3) and the rail (Item 9.4).
3.2 Removing the right-hand rail (Page 9)
Release the 4 screw couplings (Item 9.5).
Remove the rail (Item 9.6).
3.3 Removing a platform reinforcing plate (Page 9)
Release the 2 screws couplings (Item 9.7).
Remove the platform reinforcing plate (Item 9.8)
3.4 Removing a hinged ramp (Page 10)
Slacken the 2 screws (Item 10.1).
Pull off the ramp (Item 10.3), together with the end plate (Item 10.4) and unhook the end plate (Item
10.4) from the bearing in the platform (Item 10.09).
Unhook the end plate (Item 10.2) from the bearing in the platform.
Remove the 2 screws (Item 10.5) and remove the end plate (Item 10.4).
3.5 Removing a ramp stop (Page 10)
Slacken the 2 screw connections (Item 10.6).
Remove the stop (Item 10.8) and the spacer bushes (Item 10.7).
3.6. Removing the platform Insert (Page 11)
Slacken the 8 screw connections (Item 11.1).
Lift off the platform reinforcing plate (Item 11.2).
3.7 Removing the rubber elements (Page 11)
Turn off the rubber elements and lift off the washers (Pos. 11.3)
Remove the 8 bolted connections (Pos. 11.1)
3.8 Removing the mat and the screws
If require : Remove the mat (Pos. 11.4)
Attention : Remove the mat carefully to avoid overexpansions.
if require : remove the screws ( Pos. 11.5 and 11.6).