To Next Page
G
Gwendolyn DavisAug 14, 2025
What to do if the display "bAtt" appears on Seca 664 Scales?
- MMelissa CollinsAug 15, 2025
If the display shows "bAtt", it means the battery block is discharged. You should charge the battery block.
What to do if the display "bAtt" appears on Seca 664 Scales?
If the display shows "bAtt", it means the battery block is discharged. You should charge the battery block.
How to fix Seca 664 Scales when no weight is displayed?
If your Seca scale isn't displaying a weight when loaded, the issue might be that the scale is not switched on. Check to ensure the scale is powered on.
What does it mean when the display "StOP" appears on Seca 664?
If the display shows "StOP", it indicates that the maximum load has been exceeded. Remove some of the load from the scale.
What does "Er:X:12" mean on Seca 664 and how to fix it?
If the display shows "Er:X:12", it means the scale was switched on with too high a load. Remove the load from the scale and then restart it.
Why 0.00 does not appear before weighing on Seca Scales?
If "0.00" doesn't appear before weighing, it could be that a load was already on the Seca scale when it was switched on. Remove the load, switch the scale off, and then switch it back on.
What does "Er:X:11" mean on Seca Scales and how to resolve it?
If the display shows "Er:X:11", it indicates that the scale has too high a load or too much load in one corner. Remove some of the load from the scale, distribute the weight more evenly, and then restart the scale.
Why does "tEMP" appear on Seca Scales?
If the display shows "tEMP", it means that the ambient temperature of the scale is too high or too low. Set up the scale in an ambient temperature between +10 °C and +40 °C and wait approximately 15 minutes for the device to adapt to the ambient temperature.
What does "Er:X:16" mean on Seca 664?
If the display shows "Er:X:16", it indicates that the scale was caused to oscillate, and the zero point could not be determined. Restart the scale.
What does "Er:X:72" mean on Seca 664 when pressing Enter?
If the display shows "Er:X:72" when pressing Enter, it means that data transmission is not possible because no wireless group is set up.
General
