Before you really get started… • 73
5.2 Assembling the device
Fitting the column You need the following connecting elements for this
assembly step:
1. Route the display cable so that it cannot get
trapped when you fit the handrail.
2. Place the column against the handrail as shown in
the diagram above.
3. Put one serrated lock washer on each of the
screws.
4. Put the screws in the bores on the handrail and the
column.
5. Tighten the screws.
2 x serrated lock
washers
2 x hex socket head screws
To Next Page
Loading...
