62 •
Connect the power
supply unit
The rechargeable battery compartment is charged with
the included power pack.
WARNING!
Personal injury and damage to device if
incorrect power supply unit is used
The voltage provided by standard power supply
units may be higher than their indicated rating.
This may cause the scales to overheat, catch
fire, melt or short-circuit.
–Only use genuine seca plug-in power supply
units with 9 V or a controlled 12 V output
voltage.
1. Insert the power plug necessary for your power
supply in the power supply unit.
2. Insert the connector plug of the power supply unit
in the connecting socket of the scales.
3. Plug the power supply unit into a mains socket.
4. Allow the scale to charge on the network for at least
24 hours when it is first charged so that the re-
chargeable battery block is completely charged.
To Next Page
Loading...
