72 •
3. Select an attenuation level.
–0: no attenuation
–1: moderate attenuation
–2: high attenuation
4. Confirm the selection.
You will leave the menu automatically.
Switch weight unit
(Unit)
With uncalibrated scales you can select the unit you
wish to use for displaying the weight.
1. Select the item "Unit" in the menu.
2. Confirm the selection.
The current selection is displayed.
Select the unit you wish to use for displaying the
weight:
–kilos(kg)
–pounds(lbs)
– stones (sts)
3. Confirm the selection.
You will leave the menu automatically.
Restore factory settings
(RESET)
You can restore the factory settings for the following
functions:
NOTE:
The wireless module is switched off when
restoring the factory settings. Data for existing
wireless groups remains in the memory. These
groups do not need to be set up again.
Function Factory setting
Autohold (Ahold)
depending on
model
Acoustic signal (Press) off
Acoustic signal (Hold) on
Attenuation (Fil) 0
Autoclear (Aclear)
depending on
model
Pre-Tare (Pt) 0 kg
Height for body mass index
(BMI)
170 cm
Weight unit kg
Wireless module (SYS) off
Autosend (ASend) off
Autoprint (APrt) off
To Next Page
Loading...
