Secure PT3 Series - Supported Reading Parameters

Page 32 of 40
BGX701-014-R03, User Manual for PT3 Transducers
Public
9.4 Supported reading parameters for different PT3 network connections
The following table shows a list of parameters that can be read for each network type. Values of parameters not
supported by a specific network can be read but may not be displayed correctly. Such parameters are not
marked with any symbol in the table.
Please note the meaning of the following symbols:
 The parameter can be configured for analogue outputs using ConfigView. These can be read
over Modbus and ConfigView.
*
The parameter can be read only on Modbus.
Single
phase L1
Three wire, 2
-
element
asymmetric (D)
Three wire, 2
-
element balanced
U12,U23,L1
Three wire, 2
-
element balanced
U12, L1
Three wire, 2
-
element balanced
U23, L1
Three wire, 2
-
element balanced
U31, L1
Four wire, 3
-
element
asymmetric (Y)
Four w
ire, 3-
element balanced
Available
Parameters
Frequency
*
*
*
*
*
*
*
*
V1 (L-N)
 
*
V2 (L-N)

*
V3 (L-N)

*
V1 (L-L)
  
*
*
V2 (L-L)
 
*

*
V3 (L-L)
 
*
*

I1
 
*
*
*
*

*
I2
 
*
I3

*
*
*
*

*
Active Power
(Ph1)
 
*
Active Power
(Ph2)

*
Active Power
(Ph3)

*
Reactive
Power (Ph1)
 
*
Reactive
Power (Ph2)

*
Reactive
Power (Ph3)

*
Apparent
Power (Ph1)
 
*