Indicates that genset output frequency has exceeded the
pre-set threshold
Indicates that genset output frequency has fallen below
the pre-set threshold
Indicates that genset current has exceeded the pre-set
shutdown threshold
Shutdown/
Warning/
Electrical trip
Indicates that the measured kW load rating has
exceeded the pre-set threshold
Shutdown/
Warning/
Electrical trip/
Notification
Load on any phase is greater or less than other phases
by a threshold value
Shutdown/
Warning/
Electrical trip/
Notification
Indicates that genset speed has exceeded the pre-set
over speed threshold
Indicates that genset speed has exceeded the pre-set
gross over speed threshold (This threshold is
configurable percentage value of over speed threshold)
The engine speed has fallen below the pre-set RPM
Indicates that there was 100% load on the genset for one
hour in the time interval of 12 hours
The charging alternator voltage has dropped below the
supply voltage
Shutdown/
Warning/
Electrical trip/
Notification
Indicates that there is failure of the V-belt, which is
driving the charging alternator
Shutdown/
Warning/
Electrical trip/
Notification
The battery voltage has fallen below the pre-set
threshold
Shutdown/
Warning/
Electrical trip/
Notification
The battery voltage has exceeded the pre-set threshold
Shutdown/
Warning/
Electrical trip/
Notification
Indicates that engine running hours has exceeded the
pre-set hours limit or maintenance due date has
occurred, and filter servicing is required.
Indicates the mains unhealthy condition
To Next Page
Loading...
Need help?
General
