3.3
Tool preparation for eMMC wire brush
⚫
1 Hardware tool: a computer PC
⚫
2 Hardware tool: one TYPC-C data cable (with data signal cable inside)
⚫
3 Hardware: one card picker thimble (pin for inserting cards in mobile phones, used to
poke holes)
⚫
4 Software tool: RK chip driver tool [DriverAssitant_v5.12].
⚫
5 Software tool: RK firmware burning tool [RKDevTool_Release_v2.84 - for downloading OP
firmware].
⚫
6 Software material: one case firmware package [Android xxx.img] [H68K-Boot-Loader.bin]
[OPxxx.img]
3.4
eMMC wire brush operation procedure
⚫
Step 1: Install the driver
Double click on [Driv
erInstall] in the [DriverAssitant_v5.12] folder
Click on [Driver Installation] Click on Install Driver to finish [OK]
To Next Page
Loading...