54
EXPLANATION OF TEST AND DATA DISPLAY
9
9-3a INPUT TEST
The condition of each input device can be checked. Periodically check the condition of each input device on this
screen.
<Operation>
1
Manipulate the control unit (Gun) and confirm that the input value (GUN-X and GUN-Y) on the right side
of the item changes smoothly in response to manipulation.
2
Manipulate the trigger, action, change and the start buttons and check the display on the right side of the
item. The display is normal if it shows ON when trigger or button is pressed and OFF when trigger or but-
ton is released.
3
Use the TEST Button and SERVICE Button and check the values shown on the right of each category.
Operation is normal if it shows ON when pressed and OFF when released.
4
When the SERVICE Button and TEST Button are pressed simultaneously, the game test mode menu screen
reappears.
<Menu Explanation>
TRIGGER: Controller trigger
ACTION: Controller Action button.
CHANGE: Controller shot selector button.
GUN X: Control unit left/right input value
GUN Y: Control unit up/down input value
SCREEN: Controller Sensor
START BUTTON: Start button
SERVICE: SERVICE Button
TEST: TEST Button
FIG. 9-3a01 INPUT TEST Screen
INPUT TEST
PLAYER 1 2
TRIGGER OFF OFF
ACTION OFF OFF
CHANGE OFF OFF
GUN-X 000 000
GUN-Y 000 000
SCREEN OUT OUT
START OFF OFF
SERVICE OFF
TEST OFF
PRESS TEST AND SERVICE BUTTON TO EXIT
To Next Page
Loading...
