PROJECTOR
69
10
CONVERGENCE ADJUSTMENT
10.7
● To avoid circuitry malfunctioning due to electrical load increase, never utilize
CONVERGENCE ADJUSTMENT (Line Convergence Adjustment in particular) for
adjusting screen size changes.
There is no means to restore the Convergence Adjustment data once stored, to its
original state. To avoid changing the screen size by erroneously using convergence
adjustment, do not perform the green Line Convergence Adjustment. As such, be
sure to perform the adjustment work from this page onward by the Technical staff
and the Location’s Maintenance Man who are well versed in such adjustment
work. In the Static Convergence Adjustments, if satisfactory adjustments can not
be performed, do not make another convergence adjustments inadvertently.
Contact the office herein stated or where the product was purchased from.
• To avoid making the adjustment work ineffective, do not press the RESET button
during adjustment.
• To discontinue adjustment work, keep pressing the TEST button for approximately
3 seconds at the stage before storing the adjustment data by pressing the
WRITING button.
• Should the screen be abnormally disturbed by noise due to static electricity, etc.,
turn the power off without storing the adjustment data.
To Next Page
Loading...
Need help?
General
